What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
12.06.2025 09:59

There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
The other is “what does a “fuse” do?”
It also is a device that limits the change in current flow.
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
Are INFJs essentially the most introverted type?
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
Here is a simplified AC power diagram.
These are simplified answers to the original question, and does not change anything I wrote above.
SEC Raises Legal Questions Over Proposed Ethereum, Solana ETFs - Decrypt
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
He then describes Rainy Season and Lightning.
How are you able to read words without vowels? - Live Science
Can the fuse protect the electronic devices from lightning instead of a surge protector.
This is the picture of an electronic coil of wire wound around a core of magnetic material.
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
a photo is worth a thousand words.
This device then solves the entire problem.
Barnstars:
Edit 2024–10.
It seems Mohan does not understand the difference between a comment and an Answer.
These devices are installed between the “hot” and “neutral” and protective ground.
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
A circuit breaker is similar, but is resettable.
Can you write a poem or short story based on the first image that shows up on Pinterest?
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
what exactly is a ‘surge’ protector?
the problem then depends on "how fast does the fuse operate?".
Horoscope for Sunday, June 08, 2025 - Chicago Sun-Times
nine
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
but I think this circuit , shows a few more pieces.
What celebrity do you admire the most?
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
First Sentence:
Upvotes:
Because the load is inductive, the current lags the voltage.(by a bit).
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
This is where the MOV conducts again, and dissipated the energy.
2024–10–16 [ OO OLAOYE OYEBODE ]
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
This is where this question deviates from being a 'generic' question, and becomes more specific.
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
[old diagram got deleted by accident]
but this device (an Inductor) … impedes the rapid changes in the current.
One is “what exactly is in a ‘surge protector’ ? ”
There are three different concepts here that are getting confused.
[image of Common-mode choke]
eight
An AC voltage/ current source, and an ac inductive load.
The MOV will conduct when the voltage exceeds 50% of line voltage.
2024–10–14 [Omar Gharbi Omar Gharbi ]
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
At one ohm, the resistor has a maximum of 1 watt power.
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
But… the neutral is now “floating” because of the 1 ohm resistance.
For this case there are devices called Metal oxide varistors (MOV).
But it can get overloaded, and no longer works.
One
The bolt then partially travels down the line to your home.
A fuse is a non-resetable over current circuit protector.
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
This one hit behind the barn.
At least they know the answer if they wanted it.
He then asserts :
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
The third is lightning and “how it gets conducted into a home.”
This is 'the assistant's answer'
(Dc diagram shown, AC is similar).
So, the voltage could go up to 500 volts, and the fuse will not open up.
What does a fuse do?
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
He then describes the function of a fuse.
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
2024–10–10[John johnson John Johnson ]
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
so, what happens?
In schematic diagrams this is the symbol for a fuse:
What is lightning?
I post the exact comment here.
There are two important concepts here.
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
Now when you have a certain ac resistance, then a current flows in a loop.